Installation guide

23
5. Type cu -l ttyS0 -s 38400 at the Linux prompt. The L1
responds with “Connected” as shown:
$ cu -l ttyS0 -s 38400
Connected.
6. Press the Enter key to display the L1 prompt.
001c04>
Connecting the Workstation to a C-brick L1 Port
To connect a Silicon Graphics 230 visual workstation to the L1 port (USB
port) on the SGI Origin 3200 server C-brick, follow these steps (see
Figure 6):
1. Power off the workstation and the SGI Origin 3200 server.
2. Connect a USB cable from the workstation to the L1 port (USB port)
on the C-brick.
3. Ensure that you are in the /stand/sysco/bin directory.
4. Type the following at the Linux prompt to establish a connection:
$ ./l2
Note: Ensure that the L1 network auto-detect is enabled or ensure
that the C-brick network interface ports are set to 422 protocol.
L3Con_Install.fm Page 23 Tuesday, February 27, 2001 8:01 AM