Installation guide
20
4. Enter the following command to load the diagnostic software:
# l3_install
5. Remove the SGI Origin 3000 series L3 controller CD-ROM.
6. Reboot the system.
Installing the Software from the Network
To install the L3 controller software from the network, follow these steps:
1. Go to the following website:
http://www.sgi.com/products/evaluation/
2. Scroll down the page and click on Origin 3000 Series L3 Controller
1.2.
Note: The release number may vary as new releases of the software
are released.
3. Follow the website instructions until you have completed the
installation.
L3Con_Install.fm Page 20 Tuesday, February 27, 2001 8:01 AM