Installation guide

2
Installation Overview
To install an SGI Origin 3000 series L3 controller, you must do the
following:
1. Read the software installation requirements so that you have all the
items and information that you need to complete the installation.
2. Configure and install the Red Hat Linux 6.2 operating system and
auxiliary Linux software components (via a CD-ROM or download)
on the Silicon Graphics 230 visual workstation.
3. Install the L3 controller software (via CD-ROM or download) on the
Silicon Graphics 230 visual workstation.
4. Connect the Silicon Graphics 230 visual workstation to an SGI
Origin 3000 series server that runs the IRIX 6.5.10 operating system
or newer.
These procedures are explained in the following sections:
Software Installation Requirements
Make sure that you have received or can download the software listed in
Table 1 from the workstation before you install the software. If you do not
have the CD-ROMs with the software and cannot download the software,
order the software on CD-ROM from the locations listed in Table 1.
L3Con_Install.fm Page 2 Tuesday, February 27, 2001 8:01 AM