Installation guide

19
Installing the L3 Controller Software
The L3 controller software consists of the following components:
• Kernel software
• L3 driver
• L1/L2 firmware utilities
• L3 installation tool
This section describes the following:
• Installing the software from the CD-ROM.
• Installing the software from the network.
Installing the Software from the CD-ROM
To install the L3 controller software from the CD-ROM, follow these
steps:
1. Log on to the Silicon Graphics 230 workstation as root.
2. Insert the SGI Origin 3000 series L3 controller CD-ROM into the
CD-ROM drive.
3. Type the following at the superuser prompt to change the directory:
# cd /mnt/cdrom/RPMS
L3Con_Install.fm Page 19 Tuesday, February 27, 2001 8:01 AM