Installation guide

16
workstation and monitor configuration may require other settings. You
may manually input these settings if the option you require is not
displayed.
1. Select the monitor configuration; click Next to install the Red Hat
Linux 6.2 operating system.
Note: Most monitors use the DDC Probed Monitor-->(YOUR
MONITOR TYPE) option.
2. Select the video card that is installed in your workstation, and then
click Next.
Note: Standard Silicon Graphics 230 visual workstation users
should select the NVIDIA GeForce DDR Generic video card.
3. Select the memory requirement, and then click Next.
Note: Standard Silicon Graphics 230 visual workstation users
should select 16384k as the memory requirement.
4. Select the preferred user interface.
Note: Most users prefer to use the Graphical Login interface option.
5. Click the Test this Configuration button to verify that your X
configuration settings are correct. If no image displays on the
monitor, repeat the steps in this section until the X configuration
test displays an image on the monitor.
6. Click Next to continue.
7. Install Red Hat Linux 6.2, as explained in the next section.
L3Con_Install.fm Page 16 Tuesday, February 27, 2001 8:01 AM