User`s guide

SGI
®
10-Gigabit Ethernet Network Adapter User’s Guide
The output will display information about the network adapters currently
installed in the system, as follows:
Name Mtu Network Address Ipkts Ierrs Opkts Oerrs Coll
xg1 1500 10.50.1 system.name 0 0 1 0 0
2. To bring down the adapter, enter the following command, where N is the number
of the adapter:
ifconfig xgN down
3. To change the MTU size of the 10-Gbit Ethernet adapter, enter the following
command, where Nis the number of the adapter:
ifconfig xgN mtu 9600
4. To restart the adapter, enter the following:
ifconfig xgN up
5. Enter the following command to verify that the MTU size has been changed:
netstat -i
The output should look similar to the following:
Name Mtu Network Address Ipkts Ierrs Opkts Oerrs Coll
xg1 9600 10.50.1 system.name 0 0 3 0 0
007–4669–003 15