User`s guide

30 007-5536-001
4: Internal Component Replacement and Upgrades
Figure 4-5 Power Supply Removal Example (System Top Cover Removal Not Required)
Installing a New Power Supply
Use the following steps to replace a failed power supply in the server:
1. Replace the failed power supply with the exact same model from SGI or another approved
vendor, contact your sales or service representative for more information.
2. Insert the new unit into the chassis and push it in until seated. This may require some
moderate force but you should hear an audible “click” as the power supply is seated.
3. Reconnect the AC power cord and then press the power buttons on the front of the chassis to
resupply power to both nodes.