User`s guide

Installing the System into a Rack
007-5536-001 15
Figure 2-3 Sliding the Server into a Rack
Server Access After Rack Installation
After you install the unit in the rack, you will need to open the top cover to make sure the
serverboard is properly installed and all the connections have been made.
Grasp the two handles on either side and pull the system straight out until it locks (you should hear
a "click").
Remove the four screws (two on the sides and two on the top) that secure the top cover to the
chassis. Place your thumbs in the two rectangular recesses and push the cover away from you