User`s guide

Changing the NIC1 (Customer Domain) IP Address
007-5474-003 17
– Click the “IP Address” box for device eth0 and change the IP address
– Click the “Subnet” box for each network and select (arrow) the new subnet
9. Click in the “Default Gateway” tab. Click on the “Gateway IP Address” and change it to
your network address
10. Click on the “NAT Settings” tab and configure any NAT settings (if applicable). See the Add
and Remove buttons (lower right) in the window.
11. Click on the “DNS Settings” tab to enable, disable and configure DNS.
– Right click on the DNS entry to make selected appropriate changes
12. When all changes have been made:
– Click on the “Network Interfaces” tab
– Click “Save” (lower right)
– Click “OK” to confirm
– Click “Apply Changes” when prompted to “Update configuration files now”
– Wait for the node configuration task to complete
You may see some errors with the Platform manage GUI. If this occurs, you can troubleshoot the
problem by bringing up a Terminal window and running the following commands:
/etc/init.d/scance restart
You may have to edit the /etc/hosts file and manually change any entries with the old
hostname/IP to the new one. Then enter the following command:
platformmanage-cli reconfigure all
Wait for the job to complete and return back to the prompt.
It is best to reboot the headnode also.
When you re-launch the pmgui interface, you will have to enter the new hostname, user (root),
and password (factory default is sgisgi).