User`s guide

10 007-5476-001
2: Connecting the Adapter to a Network
Procedure 2
1. Remove one or two adjacent DIMMs.
2. Remove the chassis-mounted bracket latch of the adapter.
The bracket latch is the small assembly attached at the top of the slot with two
screws.
Procedure 3 (Most Complex)
Note: This procedure is required for the PCIE-10G-C-RDMA version (part number
030-2313-001) of the adapter.
1. Remove one or two adjacent DIMMs.
2. Remove the short PCIe riser assembly from the chassis (one screw).
3. Position the card on the chassis sheet metal slot so that the lower bracket lip will be
inserted into its chassis lock.
4. Position the riser to couple with the adapter.
5. Position the entire assembly to couple with the motherboard.
Driver Specification Needed for SGI Altix 450 and SGI Altix 4700 Platforms
On SGI Altix 450 and SGI Altix 4700 platforms, you must ensure that the file
/etc/modprobe.conf.local contains an entry like the following:
options cxgb3 msi=0
Connecting to a Network
This section describes how you connect the adapter to a network in the following
sections:
• “Connecting with a Fiber-Optic Cable” on page 11
• “Connecting with a Copper Cable” on page 12