User`s guide

SGI
®
Altix
®
XE210 User’s Guide xiii
List of Figures
Figure 1. SGI Altix XE210 Server System................................................................................. 1
Figure 2. Chassis Components................................................................................................. 4
Figure 3. Server Board Connector and Component Locations ................................................. 6
Figure 4. BIOS Select Jumper................................................................................................... 7
Figure 5. Recovery Jumpers ..................................................................................................... 8
Figure 6. Light-Guided Diagnostic LEDs................................................................................... 9
Figure 7. Back Panel Connectors............................................................................................ 10
Figure 8. Active Backplane Components ................................................................................ 12
Figure 9. Passive Backplane Components ............................................................................. 13
Figure 10. Control Panel ......................................................................................................... 15
Figure 11. Server System Back............................................................................................... 15
Figure 12. Optical and Hard Drive Bays.................................................................................. 16
Figure 13. The Front Bezel...................................................................................................... 22
Figure 14. Removing the Front Bezel...................................................................................... 22
Figure 15. Installing the Front Bezel........................................................................................ 23
Figure 16. Removing the Server System Cover...................................................................... 24
Figure 17. Installing the Server System Cover........................................................................ 25
Figure 18. Removing the Processor Air Duct.......................................................................... 26
Figure 19. Removing the Processor 2 Air Dam (only if two processors are installed) ............ 27
Figure 20. Installing the Processor Air Duct............................................................................ 28
Figure 21. Minimum Population for Dual-Channel Mode with Identical FBDIMMs.................. 29
Figure 22. Standard DIMM Population for Sparing or Mirroring Mode.................................... 31
Figure 23. Installing the Memory............................................................................................. 32
Figure 24. Lifting the Processor Socket Handle...................................................................... 34
Figure 25. Installing the Processor.......................................................................................... 35
Figure 26. Removing the Socket Cover .................................................................................. 35
Figure 27. Installing the Heat Sink (2U Passive Heat Sink Shown) ........................................ 42
Figure 28. Removing the Small Air Baffle ............................................................................... 44
Figure 29. Installing the Small Air Baffle ................................................................................. 45
Figure 30. Removing Hot-swap Disk Carrier from the Server System.................................... 46
Figure 31. Removing Retention Device from Drive Carrier..................................................... 46
Figure 32. Installing Hard Drive into Carrier............................................................................ 47
Figure 33. Install Drive Assemby into the Server System ....................................................... 47
Figure 34. Installing an Optical Drive into the Drive Tray........................................................ 49
Figure 35. Installing an Optical Drive Assembly into the Server System ................................ 50
Figure 36. Removing the Slimline Optical Drive Assembly from the Server ........................... 51
Figure 37. Removing the Slimline Optical Drive from the Tray ............................................... 51
Figure 38. Removing PCI Riser Assembly from the Server System ....................................... 53
Figure 39. Installing PCI Riser Assembly into the Server System........................................... 54
Figure 40. Removing the PCI Express* Riser Card ................................................................ 56
Figure 41. Installing the PCI-X* Riser Card............................................................................. 57
Figure 42. IInstalling a Full-Height Add-In Card ...................................................................... 58