Technical data

Booting Your System

Boot your system by performing the following steps:

1. Power on the system, as described in the preceding section, “Powering On the

System.”

2. Go the front the chassis module and insert the system key into the key switch,

located to the right of the module System Controller’s (MSC) display. Turn the key

switch to the On position (see Figure 5-9).

Note: The MSC begins the power-on sequence. The green power-on LED, located

above the function buttons, lights to indicate that power has been applied to the

system midplane. The amber fault LED then lights to indicate that power has been

supplied to the MSC. The fault LED goes out when the MSC has successfully

initialized and the power-on tests have completed.

3. Repeat this process with additional modules as required.