Technical data

96
Chapter 6: Removing and Replacing Customer-Replaceable Units
Removing the System Controller and CD-ROM Module
The System Controller and CD-ROM drive are packaged together in one assembly. To
replace either component, you must remove and insert an entire new assembly.
Caution: Do not attempt to remove the MMSC and display. This procedure should only
be performed by Silicon Graphics-certified personnel.
1. Power off the system (see “Powering Off a Rackmount System” on page 82).
2. Remove the facade (see “Removing the Facade” on page 94).
3. Remove and reserve the screws that hold the assembly in place, as shown in
Figure 6-12.
4. Insert the new assembly, using the reserved screws.
5. Repackage the old assembly.