User`s guide

82 007-4274-001

4: Removing and Installing User Serviceable Components

2. Determine which drive needs to be removed. If necessary, use the LED states below

to make this determination.

3. Depress the handle lock with your thumb.

4. Gently pull the locking handle away from the chassis until the handle disengages.

5. Grasp the locking handle and pull it toward you to disengage the drive connector

from the backplane connector. The locking handle is noted by “A” in Figure 4-3.

Figure 4-3 Disengaging Drive Carrier from Chassis

Table 4-1 Hard Drive LED State Status

LED State Status

Solid green The hard drive is present and powered on.

Flashing green The hard drive is active.

Solid yellow There is an asserted fault status on the hard drive.

Flashing yellow A rebuild of the hard drive is in progress.

Off The hard drive is not powered on.