User`s guide

SCSI Hard drives
007-4274-001 81
D. SCA2 Connector
E. Locking Handle
Removing a SCSI Hard drive
AbankoffiveLEDsonthefrontoftheharddrivebaysmonitorsthedrivestatusofeach
drive in the hot-docking bay. Each LED corresponds directly to a drive, so that the left
most LED shows activity in the left most drive. The LEDs and corresponding drives are
numbered (left to right) zero to four. When a yellow LED for a hard drive is on
continuously, you are permitted to hot-swap (replace) a bad drive with a good one. If the
operating system installed supports hot-swapping hard drives, the system does not need
to be powered off.
To remove a SCSI hard drive, perform the following steps:
1. Open the front bezel door by simultaneously pulling on the raised lip of the front
bezel door and putting counter pressure on the bezel latch area. See Figure 4-2 for
an illustration of the procedure.
Figure 4-2 Opening the Front Bezel Door