User`s guide

8 007-4274-001

1: Chassis Description

Device Bay

The device bay accommodates either a 5.25-inch CD-ROM or a DAT drive. Only

qualified service technicians should remove and install components in the device bay.

Media Bay

The media bay accommodates a 0.5-inch slim line floppy drive and 0.5-inch slim line

CD-ROM drive. Only qualified service technicians should remove and install

components in the media bay.

Hard Drive Bay

The chassis contains one hard drive bay. The hard drive bay can accommodate up to five

3.5-inch by 1.0-inch hot-swap Ultra 160 SCSI SCA hard disk drives

Opening the front bezel door provides user access to the hard drives. As part of the

hot-swap implementation, each hard drive requires a hard drive carrier. When you

remove a hard drive from the system, you remove both the carrier and the hard drive.

The drive is attached to the carrier by four screws. The carrier locks into the hard drive

bay by a locking handle. Figure 1-4 shows the orientation of the drive in the carrier. The

carrier is upside down in this figure.

Figure 1-4 Hard Drive in Drive Carrier

A. Hard Drive Carrier

B. Two (of four) Fasteners Used to Attach Drive to Carrier