Specifications
Table Of Contents
- SGI™ 1400 Server Family Maintenance and Upgrades Guide
- List of Figures
- List of Tables
- About This Guide
- Working Inside the System
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover
- Warnings and Cautions
- Removing the System Access Cover
- Installing the Access Cover
- Working in the Subchassis and Electronics Bay
- Installing PCI Boards
- Removing a PCI option Board
- Removing the Front Panel Board
- Installing the Front Panel Board
- Removing the Diskette Drive
- Installing the Diskette Drive
- Peripheral Drives
- System Fans
- The Power Share Board
- Upgrading Baseboard Components
- SGI 1400 Server SCSI Backplane Installation
- Technical Reference
- Baseboard Connectors
- Main Power Connector
- Auxiliary Power
- Diskette Drive
- Front Panel Connector
- The SMM Connector
- The IPMB Connector
- VGA Video Port Connector
- Keyboard and Mouse
- Parallel Port
- Serial Ports A and B
- Universal Serial Bus
- Narrow SCSI Connector
- Wide SCSI Connector
- Internal IDE Connector
- The Hard Drive LED Connector
- ISA Connector Pinouts
- The PCI Connectors
- Baseboard Jumpers
- System I/O Addresses
- Memory Map Address Range
- Interrupts
- Video Modes
- Baseboard Connectors
- Equipment Log and Configuration Worksheets
- Environmental Specifications
- Chassis Warnings and Safety
- Index

System Fans
25
Note: Thetwoinstalled fans nearestthe 5.25-inch drivebays(fans 6 and7)areseparated
by a square piece of foam (the piece with a crescent-shaped hole) that extends
perpendicularly from the front of the fans (it is the rectangle between the round faces of
fans 6 and 7). You must remove this piece to access the two fans it separates (pull it
straight out).
Figure 1-12 Fan Cabling
1
7
5
3
2
4
6
8
1
2
8
3
5
4
7
6
1
3
5
7
2
4
6
8
5
1
7
6
3
8
2
4