Specifications

Peripheral Drives
17
Figure 1-8 Snap-in Plastic Slide Rails
The components shown in Figure 1-8 are:
1. Tape drive or other removable media device
2. Tab on slide rail
3. Screws (quantity 4)
4. Slide rails (quantity 2)
Complete the installation of the new 5.25-inch drive using the following steps:
1. Position the drive so the plastic slide rails engage in the bay guide rails. Push the
drive into the bay until the slide rails lock in place.
2. Connect apower cable to the drive. Theconnectors are keyedand can be inserted in
only one way.
1
4
3
2