Specifications
Table Of Contents
- SGI™ 1400 Server Family Maintenance and Upgrades Guide
- List of Figures
- List of Tables
- About This Guide
- Working Inside the System
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover
- Warnings and Cautions
- Removing the System Access Cover
- Installing the Access Cover
- Working in the Subchassis and Electronics Bay
- Installing PCI Boards
- Removing a PCI option Board
- Removing the Front Panel Board
- Installing the Front Panel Board
- Removing the Diskette Drive
- Installing the Diskette Drive
- Peripheral Drives
- System Fans
- The Power Share Board
- Upgrading Baseboard Components
- SGI 1400 Server SCSI Backplane Installation
- Technical Reference
- Baseboard Connectors
- Main Power Connector
- Auxiliary Power
- Diskette Drive
- Front Panel Connector
- The SMM Connector
- The IPMB Connector
- VGA Video Port Connector
- Keyboard and Mouse
- Parallel Port
- Serial Ports A and B
- Universal Serial Bus
- Narrow SCSI Connector
- Wide SCSI Connector
- Internal IDE Connector
- The Hard Drive LED Connector
- ISA Connector Pinouts
- The PCI Connectors
- Baseboard Jumpers
- System I/O Addresses
- Memory Map Address Range
- Interrupts
- Video Modes
- Baseboard Connectors
- Equipment Log and Configuration Worksheets
- Environmental Specifications
- Chassis Warnings and Safety
- Index
145
Index
front panel
connectors on baseboard, 72
front panel control board
installing board, 10
location of board in chassis, 9
removing board, 9
G
gasket, EMI protection at I/O connectors, 34, 35
grounding clip, removable media drives, 15
H
heatsinks
installing on S.E.C. cartridge, 47
I
IDE
cable, must disconnect to reuse interrupt, 13
cable considerations, 13
connectors on baseboard, 18
indicators
removing front panel control board, 9
installing termination board, 44
interrupt
mapping, 109
must disconnect IDE cable to reuse interrupt, 13
I/O
address, 104
ISA
connectors on baseboard, 89
installing add-in board, 7
removing add-in board, 9
run SSU after installing or removing
add-in board, 9
J
jumpers
CMOS clear, 100
do not damage when changing, 33
location on baseboard, 99
password, 100
recovery boot, 100
L
lithium backup battery
disposing of safely, 53
installing, 55
removing, 53
M
main, 68
memory
installing DIMM, 39
installing memory module, 38
removing DIMM, 38
removing memory module, 36
run SSU to configure ECC memory, 36
memory module
installing, 38
removing, 36