Specifications
Table Of Contents
- SGI™ 1400 Server Family Maintenance and Upgrades Guide
- List of Figures
- List of Tables
- About This Guide
- Working Inside the System
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover
- Warnings and Cautions
- Removing the System Access Cover
- Installing the Access Cover
- Working in the Subchassis and Electronics Bay
- Installing PCI Boards
- Removing a PCI option Board
- Removing the Front Panel Board
- Installing the Front Panel Board
- Removing the Diskette Drive
- Installing the Diskette Drive
- Peripheral Drives
- System Fans
- The Power Share Board
- Upgrading Baseboard Components
- SGI 1400 Server SCSI Backplane Installation
- Technical Reference
- Baseboard Connectors
- Main Power Connector
- Auxiliary Power
- Diskette Drive
- Front Panel Connector
- The SMM Connector
- The IPMB Connector
- VGA Video Port Connector
- Keyboard and Mouse
- Parallel Port
- Serial Ports A and B
- Universal Serial Bus
- Narrow SCSI Connector
- Wide SCSI Connector
- Internal IDE Connector
- The Hard Drive LED Connector
- ISA Connector Pinouts
- The PCI Connectors
- Baseboard Jumpers
- System I/O Addresses
- Memory Map Address Range
- Interrupts
- Video Modes
- Baseboard Connectors
- Equipment Log and Configuration Worksheets
- Environmental Specifications
- Chassis Warnings and Safety
- Index
139
Appendix C
C. Chassis Warnings and Safety
The following sections contain general chassis and power related safety warnings.
Power Warnings
Thepower supply inthisproductcontainsno user-serviceableparts. Theremay be more
than one supply in this product. Servicing is done only by qualified personnel.
Do not attempt to modify or use the supplied AC power cord if it is not the exact type
required. A product with more than one power supply will have a separate AC power
cord for each supply.
TheDC push-button on/offswitch on thesystem doesnot turnoffsystem AC power.To
removeAC power fromthesystem, you must unplugeachACpower cordfromthe wall
outlet or power supply.
Cautions When Removing the Chassis Covers
Whenever youremove the chassis covers to access the insideof thesystem, followthese
steps:
1. Turn off all peripheral devices connected to the system.
2. Turn off the system by using the push-button on/off power switch on the system.
3. Unplug all AC power cords from the system or from wall outlets.
4. Label and disconnect all cables connected to I/O connectors or ports on the back of
the system.