User`s guide

138
Appendix B: SGI 1400 Server Rackmount Installation
Attach the Small Bar of the Slide Assembly to the Server
Use Figure B-2 and the following steps to properly attach the small bar of the slide
assembly to the server chassis.
1. Remove four screws from the kit.
2. While facing the side of the server, orient the small bar so that the flat side faces the
top and the right-angle end faces the front of the server.
3. Align the first hole in the right-angle end of the bar with the first threaded hole in
the side of the chassis.
4. Insert a screw through the hole in the bar and into the chassis wall. Then loosely
tighten the screw.
5. Align the rest of the holes in the bar with the remaining three threaded holes along
the side of the chassis.
6. Insert three more screws through the bar and into the threaded holes in the chassis
wall. Then tighten all four screws firmly (6.0 inch-pounds).
7. To install the remaining small bar on the other side of the chassis, repeat steps 1–6.