User`s guide

Prepare the Slide Assemblies
137
Prepare the Server
Before you can install theserver in the 19-inch equipment rack, you must installa bezel,
handles, and the small bars of the slide assemblies onto the sides of the server.
Attaching the Bezel Frame and Door
To be installed in a rack, the server needs a bezel frame with rectangular cutouts where
the chassis handles fit.
1. Attach the bezel frame by inserting the tabs at the corner of the frame into their
corresponding rectangular slots on the chassis.
2. Attach the bezel door: with the door all the way open (down, as the server lay as it
would when inserted in a rack), align the tabs on the door with their corresponding
hinge loops on the chassis; slide the door to the right to engage the tabs in the loops.
Attach the Chassis Handles
Beforeyoucanattachthechassishandles,theserver must be on its side,inthehorizontal
position in which you will slide it into the rack. If the server is not already in the proper
position, you must move it. See step one, below.
Caution: The server is heavy (up to 45 kg [100 lbs]), be sure to read all the warnings at
the beginning of this appendix. Always use at least two people to mount the server in a
rack.
1. If the server is not already in the proper position, then face the front of the server
and, with the help of a mechanical assist unit, carefully tip it onto its side. The long
front edges (19 inches) should now be horizontal; the short front edges (12.25
inches) should now be vertical, with the front-panel LEDs at the top left and the
hard drive bays at the bottom right of the front panel.
The bezel frame has rectangular cutouts on its edges where the chassis handles fit;
you should be able to see two threaded holes in that cut-out space where the
handles attach to the chassis.
2. Orient each handle so the two screw holes on the long edge of each handle align
with the threaded holes in the chassis. Because the bezel frame’s cutouts act as
guides, the handles can be installed in only one way.
3. Use four screws from the kit to attach the handles to the chassis.