User`s guide

Prepare the Slide Assemblies
135
Prepare the Slide Assemblies
Use Figure B-1 and the following steps to prepare the rackmounting slide assemblies.
1. Remove the slide assemblies from the kit.
2. Orient a slide assembly so that the smallest outer bar is facing down.
3. Fully extend the telescoping slide assembly until the center bar hits the safety latch
on the small outer bar (all three overlapping bars will be visible).
4. Grasp the small outer bar with your hand so that your thumb is on the safety latch
of the small outer bar.
5. Pressand hold the safetylatch down, andat thesame time,grasp thelarge outer bar
with your free hand.
6. Pull the small bar out of the center bar; this takes a little force to separate them. Set
the small bar aside to attach to the chassis in a later step.
7. Orient thecenter bar and largeouter bar assembly so thatthe center bar is facing up.
8. Grasp the center bar with one hand and the large outer bar with your other hand so
that your thumb is on the safety latch of the center bar.
9. Press the safety latch, and slide the bars together. Set the center bar and large outer
bar assembly aside to attach to the equipment rack in a later step.
10. Prepare the other slide assembly by repeating steps 2–9 above.