User`s guide

134
Appendix B: SGI 1400 Server Rackmount Installation
Introduction
The SGI 1400 server is designed to either stand upright (pedestal mode) or be mounted
in a rack(rack mode).Figure 1-1 in Chapter 1shows examplesofthese configurations.If
you ordered a rackmountable server, the information in this appendix explains the
proper procedure for mounting it.
Table B-1 provides size information that may help the processes of installing the server
in an EIA-compatible 19-inch equipment rack.
Tools You Need
You will need the following tools to complete the installation:
• Phillips (cross-head) screwdriver (#1 and #2 bits)
• Pencil
Table B-1 Server Physical Specifications
Specification Pedestal Mode Rack Mode
Height 48.26 cm (19 inches) 7u
Width 31.12 cm (12.25 inches) 19 inch rack
Depth 63.5 cm (25 inches) 25 inches
Weight 38.25 kg (85 lbs) minimum
configuration
45 kg (100 lbs) maximum
configuration
38.25 kg (85 lbs) minimum
configuration
45 kg (100 lbs) maximum configuration
Required front
clearance
10 inches (inlet airflow <35 ˚C / 95 ˚F) 10 inches (inlet airflow <35 ˚C / 95 ˚F)
Required rear
clearance
8 inches (no airflow restriction) 8 inches (no airflow restriction)
Required side
clearance
0.0 inches (additional side clearance
required for service)
N/A
Shock
Operating 2.0 g, 11 msec, 1/2 sine 2.0 g, 11 msec, 1/2 sine