User`s guide

124
Chapter 5: Installing or Replacing Drives and Power Supplies
Figure 5-4 Removing a Power Supply
Installing a Power Supply
Use the following steps to install a new power supply into the server.
1. Slide the power supply into its bay.
2. With even force on the flared, vertical edges, push toward the front of the system
until the edges rest against the rear of the chassis and the supply engages its
connector.
3. Install and tighten the four screws holding the supply to the back of the chassis.
4. Install the access cover.
5. Connect the AC power cable. You must slide the cover on the AC connector to
access the connector itself.
6. Run the FRUSDR load utility to properly configure the system after adding new
components, see “Sensor Data Record (SDR) Manager Add-In” in Chapter 3.