User`s guide

122
Chapter 5: Installing or Replacing Drives and Power Supplies
9. Gently push the new drive into the bay. To engage the latch, the carrier handle
should be approximately at a 45° angle from thevertical frontof the chassis.As you
push the driveinto thebay,the tworoundednotches in thecarrier handleslide onto
the two round pegs inside the drive bay (see Figure 5-3). When they engage, push
the handle straight up to lock the notches onto the pegs and press the rounded tab
on the right of the carrier to the left until it clears the edge of the bay and snaps into
place.
10. Close the metal door, and secure it to the chassis with the plastic latch.
11. For security and to prevent unauthorized access to the bays, insert a padlock
through the metal loop protruding through the door.
12. Close the front bezel.
Figure 5-3 Installing a New Drive
1. Round peg inside drive bay
2. Round notches on carrier handle (must fit over pegs in drive bay)
3. Carrier handle
3
1
2