User`s guide

SCSI Hard Disk Drives

121

1. Open the front bezel by rotating its right side out and to the left.

2. If you installed a padlock on the metal door to the bays, unlock the padlock and

remove it.

3. Loosen the plastic latch securing the metal door to the chassis, and open the door.

4. Check the bank of yellow LEDs on the front panel to determine which drive is bad.

5. Press the rounded tab (callout 2 in Figure 5-2) in on the right ofthe carrier to the left

(toward the center of the drive) while gently pulling straight down on the carrier

handle (callout 1 in Figure 5-2). This disengages the latch that secures the carrier to

the chassis.

6. Grasp the plastic carrier handle and pull it toward you to disengage the drive

connector from the backplane connector.

Figure 5-2 Disengaging Drive Carrier from Chassis

7. Carefully slide the bad drive forward out of the bay. Place the drive on an antistatic

surface.

8. Position the new plastic carrier and drive assembly so that it engages the bay guide

rails.