User`s guide

120
Chapter 5: Installing or Replacing Drives and Power Supplies
3. Orient the drive so the connector is near the top surface of the drive, then place the
plastic carrier and heatsink assembly on top of the drive (Figure 5-1).
4. Using four screws of the correct size and length, attach the carrier to the drive.
Figure 5-1 Mounting the Carrier and Heatsink Assembly to the Hard Disk Drive
Hot-swapping a SCSI Hard Disk Drive
A bank of six yellow LEDs on the front panel monitors the drive status of each drive in
the hot-docking bay. Each LED corresponds directly to a drive, so that the upper-most
LEDreflectsactivity intheupper-mostdrive.The sixLEDsandcorrespondingdrivesare
numbered(top tobottom) zero throughfive. When ayellow LED ison continuously, it is
okay to hot-swap (replace) a bad drive with a good one. You DO NOT need to shut the
system down to hot-swap a drive.