User`s guide

88
Chapter 3: Configuration Software and Utilities
Parsing the Command Line
The FRUSDRload utilityallows onlyone commandline functionat atime. A command
line function can consist of two parameters. Example: -cfg filename.cfg. Invalid
parameters cause an error message and exit the program. You can use either a slash (/)
ora minussign(-)to specifycommandlineoptions.The-p and-v flags canbeusedwith
any of the other options.
Displaying Usage Information
When the utility is run with the -? or -h command line flags, the following message is
displayed when the verbose flag -v is added to the help command:
FRU & SDR Load Utility Version 2.1 Revision R.1.1
Copyright (c) 1999, Intel Corporation, All Rights Reserved
This utility must be run from a system executing DOS. Runningin a Windows DOS box
is insufficient andwill provide incorrect results. Programming the BMC FRU area clears
the SDR table; therefore the SDR table must be reprogrammed. Upon completing the
programming of the FRU and SDR areas, the server should be rebooted.
Note: DOS users may alternatively use a ’/’ instead of the ’-’.
Usage: frusdr
-? or -h Displays usage information
-d {dmi,fru,sdr} Only displays requested area.
-cfg filename.cfg Uses custom CFG file.
-p Pause between blocks of data.
-v Verbose, display any additional details.