Specifications

PO Box 3526, Bellevue, WA. 98009 13737 SE 26
th
St. Bellevue, WA. 98005
Toll Free: 800-259-7331 * Phone: [phone] * Fax: [phone]
www.sgcworld.com * Email: [e-mail]
. 53 © 2003 SGC Inc
5.1.9.2 Antenna Too Long
Once the coupler has verified RF power, the tuning sequence
proceeds as follows:
1. Output capacitance is added until the phase switches to
capacitive.
2. At this point, series inductance is added until the antenna is no
longer capacitive.
3. Fine tuning is performed by trying a small amount of input
capacitance (this may or may not be required).
4. At this point, the program executes the same as step 5
(antenna too short).
This is a simplified program flow based on two possible antenna
conditions. Much more complex tuning is normally the case.
Further detailed description, however, is beyond the scope of this
manual.
5.1.9.3 JP1 – Tuning Elements Out during
Receive
YES - In this position the software will retain data required in
transmit to match the coupler while removing all tuning elements
when no forward power is detected.
JP1 – Factory Default
Setting - NO