User manual

55
© 1999 SGC Inc
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: [phone] or 746-7173 Tel: [phone] or 1-800-259 7331
E-mail: [e-mail] Web site: http://www.sgcworld.com
CMD Host Value Description
Command OpCode Range
PEL Not supported in Host Mode. See PAR com
mand.
PFO TC na Clears the current transmit buffer.
PID MF callsign Sets the TNC PACTOR ID. Maximum of 8
characters.
PIG IG 1…15 Sets input gain – PACTOR Mode.
PLI PN na Set controller to PACTOR Listen Mode.
POG IG 1…15 Set Output level for transmit – PACTOR Only.
PPO P1 1/2 Set Radio Port 1/2- PACTOR implementation.
POR P1 1/2 Set Radio Port 1/2
QUI Quits the TNC Control program. Not Supported
in Host Mode.
TCL TC na Clears the transmit buffer
RAS AB 45,75,110 Sets the ASCII Mode Baud Rate
RBA RB 45,75,110 Sets the Baudot Mode Baud Rate
RCV RC na Switch to Receive Mode
RFE Enable FEC Listen mode. See AL host com
mand.
RXR RX Y/N Set receive reverse ON(=Y)/OFF(=N)
SEL Not Supported, see ARQ command for Host
implementation
SIT S2 na Change operating mode to SITOR, force STBY
SPE S5 na Sets the master timing for SITOR mode, this
parameter is normally not used.
STA OP na See Section on OP Response for more informa
tion regarding response to this command.
TIM Set time. Not supported at this time
TXR TX Y/N Set transmit reverse ON(=Y)/OFF(=N)
USO US Y/N Set Unshift on space ON = Y/ OFF = N
XMI XM na Set TNC to Transmit Mode
ZF na This command returns the number of bytes
remaining in the SG-7200 transmit buffer. This
command is only available in HOST mode. The
command response is in the form of XF####
Where ### is the number of bytes in ASCII for
mat.
ZS na This command can be used to report the current
status of the transmit buffer. A return of $01
indicates that data remains to be transmitted. A
return of $00 indicates the buffer is empty. Also
See ZF host command. This command is only
available in HOST Mode.