User manual

5.4 Response to the “OP” Host Command
The OP Host command is used to report the current operating mode and
operating conditions. The following table describes this responses.
52
© 1999 SGC Inc
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: [phone] or 746-7173 Tel: [phone] or 1-800-259 7331
E-mail: [e-mail] Web site: http://www.sgcworld.com
Command Description Notes
Status
0x08 Need VIA Not used at this time. Reserved
for Packet Operation if imple
mented.
0x09 Not While Connected This command can not be used
while connected to another sta
tion. For Example, it is not
allowed to change timing para
meters when connected in an
ARQ mode.
0x0A Need MyCall Parameters Not used at this time. Reserved
for Packet Operation if imple
mented.
0x0B Need MYSELCAL Parameters No SELCAL has been set in the
TNC.
0x0C Already Connected Not used at this time. Reserved
for Packet Operation if imple
mented.
0x0D Not While Disconnected Not used at this time. Reserved
for Packet Operation if imple
mented.
0x0E Different Connectees Not used at this time. Reserved
for Packet Operation if imple
mented.
0x0F Too Many Outstanding Packets Not used at this time. Reserved
for Packet Operation if imple
mented.
0x10 Clock not Set Not used at this time. Reserved
for Packet Operation if imple
mented.
0x15 Not in this Mode This command is not available in
this operating mode. Not cur
rently used.