User manual

dropped normally. No special characters are required at the end of the
text. All necessary changeover or link commands are handled by the
program.
10.9 Logging/Text Parameters
The logging parameters deal with how the program handles logging
operation. There are two modes of operation. These are Automatic and
Manual. The automatic mode only works in linked modes of operation.
All other modes (RTTY, ASCII etc.) must be manually saved.
The Add Linefeed option (not shown below) is used to add a linefeed
character after every carriage return. This parameter is used only for
NON-Packet modes and only for typed text or brag text. File transfers
are not effected by this option. The default state for this option is OFF.
11.0 Setup Menu
11.1 Communications Port
This option allows the user to select the communications setting for the
SG-7200 DSP SmartModem. Please note that the port settings are cur-
rently fixed in the SG-7200 to 9600 Baud, 8 Data Bits and 1 Stop Bit.
11.2 Transceiver Interface Setup
This menu selection allows the user to select and configure a transceiver
interface for the program. This option should only be selected if the
radio is directly connected to the computer via an RS232 port.
Make sure that you have the correct communications settings for the
radio. If you are not sure about your radios frequency control capabili-
ties set this option to NOT Installed.
11.3 Directory / File Transfer Setup
This menu option allows the user to select the default directories for file
transfers. During the installation process the Upload, Download and
ANSI directories will be set to the SGCCOM\FILES directory.
The Text Editor button allows the user to select the default text editor
that will be called by the program for editing operations. During pro-
gram installation this is set to the standard NOTEPAD.EXE program
that is distributed with Windows 3.1 and Windows 95.
Automatic Receive Binary files is currently not used. This option will
be enabled as data transparent modes are released for the SG-7200.
11.4 Station Information
This setup option allows the user to configure the Station information,
© 1999 SGC Inc
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: [phone] or 746-7173 Tel: [phone] or 1-800-259 7331
E-mail: [e-mail] Web site: http://www.sgcworld.com
40