User manual

9.3 Entering the other Stations QTH

To enter the QTH (location) of the other station into the log, press

CTRL-Q, enter the City, State, Province etc. and press enter. You may

also highlight the QTH with the mouse and select the QTH option in the

popup menu.

9.4 Entering the Operating Frequency

To enter the current frequency into the log, press CTRL-F, enter the

frequency and press enter.

10.0 Setting Up Operating Parameters

The operating parameters tab box allows the user to customize frequently used

operations for all modes of operation. Macros are supported in these fields to

simplify communications.

To use, select the operating mode tab from the list and make required changes.

To navigate through the files press the TAB key. When finished press the OK

key to save the changes or CANCEL to abort the changes.

Here are a few basic recommendations.

1. Limit the number of lines in your CQ.

2. Allow ample time between CQ’s (CQ Delay) so that the other station can

link to you. In ARQ Modes this can take several seconds to occur.

NOTE: The Apply Button is not currently used.

10.1 CQ Repetitions

This parameter controls the number of times the program will "CALL"

an automated CQ.

Example; if the user specifies "5" for this value, the program will trans-

mit an automated CQ 5 times. Each CQ will be separated by the amount

of time delay that has been entered into "CQ Delay" .

10.2 CQ Lines

The option allows the user to specify the number ofrlines that will be

sent in the CQ.

Example parameter set to 4.

CQ CQ CQ de WI0ABC WI0ABC WI0ABC

SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA

P.O.Box 3526, 98009 Fax: 425-746-6384 or 746-7173 Tel: 425- 746-6310 or 1-800-259 7331

E-mail: sgc@sgcworld.com Web site: http://www.sgcworld.com