User manual

23
© 1999 SGC Inc
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: 425-746-6384 or 746-7173 Tel: 425- 746-6310 or 1-800-259 7331
E-mail: sgc@sgcworld.com Web site: http://www.sgcworld.com
1.0 Program Setup
The following are the steps required to install the SG-7200 control program.
This program requires either Window 3.1 or Windows 95.
1.1 Program Requirements
This program requires a 386/16mhz or faster CPU, 8 Meg of memory
and Windows 3.1 or Windows 95 (preferred). At least 2meg of avail-
able hard disk space is required for program installation.
1.2 Installation
The following steps should be followed for program installation.
1. Place distribution disk into the floppy drive.
2. Using the Run Option in the Files Menu (Win3.1) or the Start Button
(Win95), select the floppy drive and execute the SGCXXX.EXE (XXX
Version number) file on the disk. This will start the installation process.
3. Follow the on screen prompts to complete the program installation.
1.3 Configuring the Software
During the configuration process the user will have to make several
selections. Be careful when making these setting to ensure proper pro-
gram operation.
1.3.1 Selecting the Operating Mode
The program has two different operating modes. These are
Amateur operation and SITOR Operation. Amateur operation
gives the user the ability to select between AMTOR, ASCII, BAU-
DOT and PACTOR operation. The SITOR option is designed for
Ship to Shore operation.
1.3.2 Setting the Communication Parameters
Use the following settings when configuring the program
9600 baud (this is the only value that is currently supported by
the 7200.
• COM Port. The com port of the computer that the SG7200 is
connected. Be careful to select the proper port. The program sup-
ports ports 1 to 8.
• 8 data bits
• 1 stop bit
• No Parity