User manual

10.2 Pactor Mode Commands
18
© 1999 SGC Inc
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: [phone] or 746-7173 Tel: [phone] or 1-800-259 7331
E-mail: [e-mail] Web site: http://www.sgcworld.com
Command Description
PAR Start ARQ call. Station ID and remote's callsign need to be ready
and cannot be changed on the fly. Set ID with PID and remote’s call
sign with PEL commands respectively.
PAU Filter output mute. 0 = pass 1 = mute Default = 0
PBK ARQ break-in. Issues a "break-in" command in ARQ call.
PBY Force standby. Ready to respond to ARQ calls directed to this sta
tion. For response, PID must be used to set this station’s callsign.
PDY Enter Txdelay in milliseconds. 30 ms or so should be more than ade
quate. Recommended to leave the default value. Default = 30 ms
PEL Enter remote station’s callsign. Minimum of five characters, maxi
mum of eight. Enter spaces to fill if needed.
PFE Start Unproto transmission.
PFI Flush low-level input buffer.
PFO Flush low-level output buffer.
PID Enter Our Identity. Minimum of five characters, maximum of eight.
Enter spaces to fill if needed.
PIG Enter input gain in +1.5dB steps. Default 4*1.5 = 6dB.
PKE Keyboard mode. Shortcut keys: ESC=quit, ^U=Start ARQ, ^T=ARQ
Over, ^V=Force STBY, ^R=ARQ close down (^ means pressing the
CTRL key together with the next character).
PLI ARQ/Unproto listen mode. The user should enter keyboard mode
(PKE) to display traffic.
POG Enter output attenuation in +1.5dB steps. Default 0*1.5 = 0 dB
POL Sets an end-of-link request (ARQ only).
POV ARQ link “OVER”.
PPO Enter radio port number (1 or 2). Default = 1
PRS Reboot DSP and reload Pactor modem.
PTS Test. Enters a test mode where alternating mark and space are sent at
100 baud. Terminate by hitting any character.
PUN Set Unproto Speed (100/200) baud. Default is 100.
PUR Set Unproto repeat count to 1, 2, or 3 times. Default is 2.
Q shuts down and exits the 625 mode in an orderly fashion
Command Command Description Parameters
TIM Set time hh:mm:ss
TXR Set transmit reverse ON =1 OFF =0 Default = 0
USO Set Unshift on space ON =1 OFF =0 Default = 0
XMI Go to transmit
(ASCII/BAUDOT)