User manual

17
© 1999 SGC Inc
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: [phone] or 746-7173 Tel: [phone] or 1-800-259 7331
E-mail: [e-mail] Web site: http://www.sgcworld.com
Command Command Description Parameters
DSP DSP commands <1> = Rest, <11> = Select modem 1
<12> = Select modem 2
FEC Initiate AMTOR FEC
HEL Help Command
IGA Set Input Gain 16 steps - from 1-15, each step is +1.5
decibel, max of 22.5.
Default = 4 (6 db)
K Start/continue converse modeKeyboard mode. Shortcut keys:
ESC=quit, ^U=ARQ Listen, ^T=ARQ
Over, ^V=Force STBY (^ means
pressing the CTRL key together with
the next character).
L Force LTRS
(BAUDOT/AMTOR)
MAU Mute Filter output 0=pass 1=mute Default = 0
MYS Set AMTOR MYSELCAL xxxx = sender’s Selcal - 4 letters
to <xxxx>
OGA Set Output Attenuation 16 levels - 0-15, with each level -1.5
db, max 22.5. Default = 0
POR Set Radio Port 1 or 2 Default = 1
QUI Quit SGC control program
R Force STANDBY, Clears
transmit buffer
(AMTOR/ASCII/BAUDOT)
RAS Set ASCII baud rate where xxx = ASCII baud rate
to <xxx> 45,75,110 Default = 110
RBA Set BAUDOT baud rate where xxx = BAUDOT baud rate
to <xxx> 45,75,110 Default = 45
RCV Go back to receive
(ASCII/BAUDOT)
RFE Enable FEC reception ON =1 OFF =0 Default = 1
RXR Set receive reverse. ON =1 OFF =0 Default = 0
SEL Set remote SELCAL where xxxx = recipient Selcal, 4 letters
to <xxxx>
SIT Change operating mode
to SITOR, force STBY
SPE Set SITOR master timing Normally, factory setting. 447392427
to <xxxxxxxxx> counts
STA Get TOR status byte
TIM Set time hh:mm:ss