User manual

Some operating modes such as AMTOR/SITOR or PACTOR, does not
make use of the SCC but implements its own bit extraction and protocol
handling on the 386 side.
10.0 Appendix
From the CMD: prompt, type in the command from the following table. Only
the first 3 characters is required, e.g., HEL for HELP. These commands are
not case sensitive, which means you can type them as in upper or lower case
letters.
10.1 Amateur Mode (BAUDOT/ASCII/AMTOR/SITOR)
Commands
16
© 1999 SGC Inc
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: [phone] or 746-7173 Tel: [phone] or 1-800-259 7331
E-mail: [e-mail] Web site: http://www.sgcworld.com
Command Command Description Parameters
AAB Set WRU answerback <string>
AAS Set AAB ON(=1)/OFF(=0) Default = 1
ACD Set AMTOR control delay where xx = ms (milliseconds)
to <xx> Default = 5
ACH Force AMTOR break-in
ACL Close AMTOR ARQ/FEC
transmission
ACR Set display width to <xx> where xx = display width up to 80
characters characters Default = 80
ADE Set AMTOR tx delay where xx = ms (milliseconds)
to <xx> Default = 30
AL Force mode L resync
(AMTOR)
ALF Set Auto Line Feed ON =1 OFF =0 Default = 1
ALI Initiate AMTOR Listen
mode (Mode L)
AMT Change operating mode to
AMTOR, force STBY
APE Set AMTOR master timing Factory setting 536870912
to <xxxxxxxxx> counts
ARQ Initiate AMTOR ARQ Same as SELCAL <xxxx> Remote
to <xxxx> station SELCAL
ASC Change operating mode
to ASCII
BAU Change operating mode
to BAUDOT.
DAT Set date dd/mm/yyyy
DID Change RTTY diddle feature ON =1 OFF =0 Default = 1
DIS Show all parameters