Data Sheet

SGW111X BLE Modules Series Datasheet
Page 23 of 25
12.4.2. Important Note:
In the event that these conditions cannot be met (for certain configurations or co-location with
another transmitter), then the ISEDC authorization is no longer considered valid and the IC ID
cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate
ISEDC authorization.
12.4.3. End Product Labeling.
The SGW111X series are labeled with its own IC ID. If the IC ID is not visible when the module is
installed inside another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. In that case, the final end product must
be labeled in a visible area with the following:
“Contains IC: 25021-02”
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module or change RF related parameters in the user manual of the end
product.
12.5. CE Statement
12.5.1. Declaration of Conformity.
The SGW111X series are in conformity with the essential requirements and other relevant
requirements of the Radio Equipment Directive (RED) (2014/53/EU). Please note that every
application using the BGM13S22 will need to perform the radio EMC tests on the end product,
according to EN 301 489-17. It is ultimately the responsibility of the manufacturer to ensure the
compliance of the end-product.
The SGW111X series are in conformity with the essential requirements and other relevant
requirements of the radio Equipment Directive (RED) at rated 9.5 dBm transmit power. The
operating frequency range is 2402-2480MHz.
The full text of the EU declaration of conformity is available at the following internet address:
www.sgwireless.com.
This device may be used in each EU member state.