Data Sheet

SGW111X BLE Modules Series Datasheet
Page 22 of 25
"Contains FCC ID: 2AS9402"
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module or change RF related parameters in the user manual of the end
product.
12.4. IC Statement
EN: This device complies with RSS-247 of Industry Canada. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
RF exposure warning: This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with minimum
distance of 20 cm between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
FR: Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Avertissement d'exposition RF: Cet équipement est conforme aux limites d’exposition aux
rayonnements de la IC établies pour unenvironnement non contrôé. Cet équipement doit être
installé et fonctionner à au moins 20cm de distance d’un radiateur ou de votre corps.
12.4.1. OEM Responsibilities to comply with IC Regulations.
The SGW111X series have been certified for integration into products only by OEM integrators
under the following conditions:
o The antenna(s) must be installed such that a minimum separation distance as stated above
is maintained between the radiator (antenna) and all persons at all times
o The transmitter module must not be co-located or operating in conjunction with any other
antenna or transmitter
As long as the two conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed (for example, digital device
emissions, PC peripheral requirements, etc.).