Data Sheet

SGW111X BLE Modules Series Datasheet
Page 21 of 25
o The user’s manual for the host product must clearly indicate the operating requirements and
conditions that must be observed to ensure compliance with current FCC / IC RF exposure
guidelines.
o The final host / module combination may also need to be evaluated against the FCC Part 15B
criteria for unintentional radiators in order to be properly authorized for operation as a Part
15 digital device.
o This Module is full modular approval, it is limited to OEM installation ONLY.
o The module is limited to installation in mobile application.
o A separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and difference antenna configurations.
o The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module.
o The Grantee will provide guidance to the Host Manufacturer for compliance with the Part
15B requirements if requested. The transmitter module must not be co-located or operating
in conjunction with any other antenna or transmitter except in accordance with FCC multi-
transmitter product procedures.
FCC statement:
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.
12.3.3. Important Note:
In the event that the above conditions cannot be met (for certain configurations or co-location
with another transmitter), then the FCC authorization is no longer considered valid and the FCC
ID cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
12.3.4. End Product Labeling.
The variants of SGW111X series are labeled with their own FCC ID. If the FCC ID is not visible
when the module is installed inside another device, then the outside of the device into which the
module is installed must also display a label referring to the enclosed module. In that case, the final
end product must be labeled in a visible area with the following: