Data Sheet

SGW111X BLE Modules Series Datasheet
Page 20 of 25
o Reorient or relocate the receiving antenna
o Increase the separation between the equipment and receiver
o Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected
o Consult the dealer or an experienced radio/TV technician for help
12.3.1. FCC RF Exposure Information and Statement.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of 20 cm
between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesirable operation.
Any changes or modifications not expressly approved by SG Wireless could void the user’s
authority to operate the equipment.
12.3.2. Instructions to the OEM/Integrator:
This module has been granted modular approval for mobile applications. OEM integrators for host
products may use the module in their final products without additional FCC/ISED (Innovation,
Science and Economic Development Canada) certification if they meet the following conditions.
Otherwise, Additional FCC/IC approvals must be obtained.
o The OEM must comply with the FCC labeling requirements. If the module’s label is not
visible when installed, then an additional permanent label must be applied on the outside of
the finished product which states: ”Contains transmitter module FCC ID: 2AS9402”.
Additionally, the following statement should be included on the label and in the final
product’s user manual:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interferences, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.”
This device complies with Part 15C of the FCC Rules.
The antenna under test with the module is as below:
Module: SGW1110 Antenna Type: PCB Antenna Gain: 2dBi
Module: SGW1111 Antenna Type: External Antenna Gain: 3dBi