Installation manual

ManualsBrandsSG Security Communications ManualsMusical equipmentMLR2-E

TABLE OF CONTENTS

DRL2A PROGRAMMING COMMANDS 15

Entering Commands............................................................ 15

Verifying Data ...................................................................... 15

1.0 Line Card Options Programming:

LC-F7-OP-CD ...................................................................... 15

Options [00] - [0F]: 3/1, 4/1 Format Event Codes and

printer library selection .................................................. 15

Options [10] - [1F]: 4/2 Format Event Codes and

printer library Selection.................................................. 16

Options [20] - [2F]: 4/3 Format Event Codes and

printer library Selection.................................................. 16

Option [30]: Common Event Code and Library

Selection ........................................................................ 16

Option [31]: SIA Option ................................................. 16

Option [32]: Communication Select............................... 16

Option [33]: Printer Enable: Communicate

Information to Printer Through CPM2 ............................ 17

Option [34]: Receiver Number....................................... 17

Option [35]: Line Card Number ..................................... 17

Option [36]: Caller ID..................................................... 17

Option [37]: Send Caller ID to Computer ...................... 17

Option [38]: Send Caller ID to Printer ............................ 17

Option [39]: Line Check................................................. 17

Option [3A]: Programmable Output............................... 17

Option [3B]: PGM Input ................................................. 17

Option [3C]: Filter Option............................................... 17

Option [3D]: Reserved................................................... 17

Option [3E]: Mute Buzzer .............................................. 17

Option [3F]: Last Message On ...................................... 18

Option [40]: Hook Flash................................................. 18

Options [41] - [46]: Handshake Selection ..................... 18

Option [47]: Handshake and Kissoff Duration............... 18

Option [48]: Interval Delay Between Handshakes......... 18

Option [49]: 2-Way Audio (Handset) Activation Time.... 18

Option [4A]: 4-Digit Account Codes to Activate

2-Way Audio .................................................................. 18

Option [4B]: 3 Digits Account Codes to Activate

2-Way Audio .................................................................. 18

Option [4C]: Alarm Codes to Activate 2-Way Audio...... 18

Option [4D]: Audio Event Code ..................................... 19

Option [4E]: Video Downlook......................................... 19

Option [4F]: Downlook Timeout ..................................... 19

Option [50]: Audio Zone ................................................ 19

Option [51]: 3/2 Format.................................................. 19

Option [52]: 4/1 Extended Format ................................. 19

Option [53]: 4/2 Extended Format ................................. 19

Option [54]: 3/1 extended format .................................. 19

Option [55]: 4/1 Express Format.................................... 19

Option [56]: Group Arming / Disarming

with User Code .............................................................. 19

Option [57]: 4/3 Format User Conversion /

3-digit Alarm Code......................................................... 20

Option [58]: Equivalent Line .......................................... 20

Option [59]: VONK Option ............................................. 20

Option [5A]: Austel Ring ................................................ 20

Option [5B]: Double ring................................................ 20

Option [5C]: Dialer Tone................................................ 20

Option [5D]: Inter Digit time........................................... 20

Option [5E]: Inter-burst .................................................. 20

Option [5F]: Radionics 6500 computer output .............. 20

Option [60]: ScanCom 4332 .......................................... 21

Option [61]: Ademco High Speed RS-232 .................... 21

Option [62]: Scantronics RS232 .................................... 21

2.0 Buffer Output Command: LC-FA-XX-XX ........................ 21

2.1 Output Alarm Type Printer Messages

to the Printer: LC-FA-01-XX............................................ 21

2.2 Output Alarm Type Computer Messages to the Printer:

LC-FA-02-XX .................................................................. 21

2.3 Output Line Card Configuration: LC-FA-04-04 ........ 21

2.4 Output Computer Alarm Messages to the Computer:

LC-FA-06-XX .................................................................. 21

INTRODUCTION 1

CPM2 ..................................................................................... 1

DRL2A ................................................................................... 1

Power and Supervision.......................................................... 1

Compatibility.......................................................................... 1

CPM2 Outputs ....................................................................... 1

NEW FEATURES.................................................................... 1

SYSTEM OVERVIEW 2

QUICK START 3

Receiver Setup and Operation Without Programming .......... 3

Unpacking ....................................................................... 3

Introduction to Operation ................................................. 3

Bench Testing ....................................................................... 3

Power Up ......................................................................... 3

Operation with Default Program ...................................... 3

INSTALLATION 4

Mounting the Receiver .......................................................... 4

Stand-up Unit

Desk-mount Unit

Printer Connections ............................................................... 4

Telephone Line Connections................................................. 4

Grounding ............................................................................. 4

Power Supply ........................................................................ 4

Battery Charging Current ...................................................... 4

Removing and Installing System Components ..................... 5

To Remove the CPM2 Module: ........................................ 5

To Remove a Line Card Module ...................................... 5

To Install a Line Card Module .......................................... 5

Installation Checklist.............................................................. 5

MLR2-DG INSTALLATION 5

Maximum configuration ......................................................... 5

DML4 Connections ................................................................ 6

DML2A Connections ............................................................. 6

MLR2-DG Backplane Connection Diagram .......................... 7

Connections for DML2A Line Card Expansion...................... 8

DRL2A DIGITAL RECEIVER LINE CARD 9

General Information ............................................................... 9

DRL2A Features .................................................................... 9

DRL2A Controls ................................................................... 10

DRL2A OPERATING MODE 11

1.0 DRL2A Stand-By Mode ................................................. 11

1.1 Line Fault ................................................................. 11

1.2 Shutdown of Line Card Communication

with CPM2 ..........................................................................

1.3 CPM2 Error; Display Alarm Messages .................... 11

1.4 Keep Last Alarm Message ..................................... 11

1.5 Stand-by Mode ........................................................ 11

2.0 Line Card Menu Mode................................................... 11

2.1 Display Printer and Caller ID Alarm Buffer .............. 12

2.2 Display System Configuration Buffer ....................... 12

2.3 Display Program Version ......................................... 12

2.4 Adjust LCD Contrast ................................................ 12

3.0 DRL2A Cold Start-up and Changing

the Line Card Number ......................................................... 12

4.0 Communications in Progress ........................................ 13

4.1 Data Reception ........................................................ 13

4.2 Stopping Data Reception Manually ......................... 13

4.3 2-Way Audio Mode / SG-MLR2-DG Receiver

Connections ................................................................... 13