Installation manual

ManualsBrandsSG Security Communications ManualsMusical equipmentMLR2-E

5.3 Backup Current Line Card Configuration: LC-

FE-03-03

When the Line Card has been configured, the programming

changes can be recorded as a “back up” program. The

“back up” configuration may be later used to restore the

Line Card’s configuration after temporary changes are made.

To store the present Line Card configuration, enter the LC-

FE-03-03 command.

5.4: Install Backup Configuration as Current Line

Card Configuration: LC-FE-04-04

If the Line Card configuration is temporarily changed (for

example, to overcome a temporary problem or for

experimentation), the configuration stored using the LC-

FA-03-03 command may be restored.

To restore the “back up” configuration, enter the LC-FE-04-

04 command.

DRL2A Communication Formats

Common Formats

The following formats are commonly used:

• 3/1, 4/1, 4/2 formats; 10, 14, 20 baud

• 3/1 extended format; 10, 14, 20, 40 baud.

• 3/1, 4/2 formats with or without Checksum; 40 baud

• 3-2 format; 10, 14, 20 baud (option)

• 4/1 Extended format; 10, 14, 20 baud (option)

• 4/2 Extended format; 10, 14, 20, 40 baud (option)

Sur-Gard DTMF Formats

Sur-Gard DTMF 4/3 and 4/3 with Checksum formats provide

fast, reliable and easy to understand and decode data

transmission. On-line time will be greatly reduced when

using 4/3 and 4/3 with Checksum formats. The 4/1 and 4/

2 DTMF formats can also be decoded by the DRL2A.

The 4/3 with Checksum format is recommended for use

with Sur-Gard and DSC security control panels.

Ademco Contact ID Format

This DTMF format requires a dual tone handshake and

1400 Hz kissoff, or 1400Hz handshake and 1400Hz kissoff.

NOTE:NOTE:

NOTE: If the dialer responds to a 2300 Hz handshake by

sending the Contact ID Format data, the DRL2A will accept

and decode the format. The DRL2A will send a 1400Hz

kissoff tone regardless of the handshake.

The DRL2A will display a message similar to this one:

L01-1234 E130L01-1234 E130

L01-1234 E130

01 C025*01 C025*

01 C025*

Access Control - 420Access Control - 420

Access Control - 420

421 Access denied

422 Access report by user

System Disables - 500 and 510System Disables - 500 and 510

System Disables - 500 and 510

Sounder/Relay disables - 520Sounder/Relay disables - 520

Sounder/Relay disables - 520

520 Sounder/Relay disabl

521 Bell 1 disable

522 Bell 2 disable

523 Alarm relay disable

524 Trouble relay disable

525 Reversing relay disable

System peripheral Disables - 530System peripheral Disables - 530

System peripheral Disables - 530

and 540and 540

and 540

Communication Disables - 550Communication Disables - 550

Communication Disables - 550

and 560and 560

and 560

551 Dialer disabled

552 Radio xmitter disabled

Bypasses - 570Bypasses - 570

Bypasses - 570

570 Zone bypass

571 Fire bypass

572 24 Hour zone bypass

573 Burg. bypass

574 Group bypass

Test/Misc. - 600Test/Misc. - 600

Test/Misc. - 600

601 Manual trigger test

602 Periodic test report

603 Periodic RF Xmission

604 Fire test

605 Status report to follow

606 Listen-in to follow

607 Walk Test Mode

621 Event log reset

622 Event log 50% full

623 Event log 90% full

624 Event log overflow

625 Time/Date Reset

626 Time/Date inaccurate

627 Program mode Entry

628 Program mode Exit

631 Exception Schedule change

153 Loss of heat

154 Water leakage

155 Foil break

156 Day trouble

157 Low bottled gas level

158 High temp

159 Low temp

161 Loss of air flow

Fire supervisory - 200 and 210Fire supervisory - 200 and 210

Fire supervisory - 200 and 210

200 Fire supervisory

201 Low water pressure

202 Low CO2

203 Gate valve sensor

204 Low water level

205 Pump activated

206 Pump failure

System Troubles - 300 and 310System Troubles - 300 and 310

System Troubles - 300 and 310

300 System trouble

301 AC loss

302 Low system battery

303 RAM checksum bad

304 ROM checksum bad

305 System reset

306 Panel program changed

307 Self-test failure

308 System shutdown

309 Battery test failure

310 Ground fault

Sounder/Relay Troubles - 320Sounder/Relay Troubles - 320

Sounder/Relay Troubles - 320

320 Sounder/relay

321 Bell 1

322 Bell 2

323 Alarm relay

324 Trouble relay

325 Reversing

System Peripheral Troubles - 330System Peripheral Troubles - 330

System Peripheral Troubles - 330

and 340and 340

and 340

330 System Peripheral

331 Polling loop open

332 Polling loop short

333 Exp. module failure

EVENT CODES CLASSIFICATIONEVENT CODES CLASSIFICATION

EVENT CODES CLASSIFICATION

The Event codes have been grouped according to the type of event, as described below.

Medical Alarms - 100Medical Alarms - 100

Medical Alarms - 100

100 Medical

101 Pendant transmitter

102 Fail to report in

Fire Alarms - 110Fire Alarms - 110

Fire Alarms - 110

110 Fire alarm

111 Smoke

112 Combustion

113 Water Flow

114 Heat

115 Pull Station

116 Duct

117 Flame

118 Near alarm

Panic Alarms - 120Panic Alarms - 120

Panic Alarms - 120

120 Panic alarm

121 Duress

122 Silent

123 Audible

Burglar Alarms - 130Burglar Alarms - 130

Burglar Alarms - 130

130 Burglary

131 Perimeter

132 Interior

133 24 Hour

134 Entry/Exit

135 Day/Night

136 Outdoor

137 Tamper

138 Near alarm

General alarmsGeneral alarms

General alarms

140 General alarm

141 Polling loop open

142 Polling loop short

143 Expansion module failure

144 Sensor tamper

145 Expansion module tamper

24 Hour Non-Burglary - 150 and24 Hour Non-Burglary - 150 and

24 Hour Non-Burglary - 150 and

160160

160

150 24 Hour non-burg

151 Gas detected

152 Refrigeration

334 Repeater failure

335 Local printer paper out

336 Local printer failure

Communication Troubles - 350Communication Troubles - 350

Communication Troubles - 350

and 360and 360

and 360

350 Communication

351 Telco 1 fault

352 Telco 2 fault

353 Long range radio

354 Fail to communicate

355 Loss of radio supervision

356 Loss of central polling

Protection Loop Troubles - 370Protection Loop Troubles - 370

Protection Loop Troubles - 370

370 Protection loop

371 Protection loop open

372 Protection loop short

373 Fire trouble

Sensor Troubles- 380Sensor Troubles- 380

Sensor Troubles- 380

380 Sensor trouble

381 Loss of super. - RF

382 Loss of super. - RPM

383 Sensor tamper

384 RF xmtr. low battery

Open/close - 400Open/close - 400

Open/close - 400

400 Open/Close

401 O/C by user

402 Group O/C

403 Automatic O/C

404 Late to O/C

405 Deferred O/C

406 Cancel

407 Remote arm/disarm

408 Quick Arm

409 Keyswitch O/C

Remote Access - 410Remote Access - 410

Remote Access - 410

411 Callback request made

412 Succes - download access

413 Unsuccessful access

414 System shutdown

415 Dialer shutdown