77014 / 65041 Submersible Water Pumps Automatic Users Manual Carefully read this entire Instruction Manual before using this product IURQW FRYHU
Please read these operating instructions carefully and ensure they are strictly followed. Please retain these instructions for future reference. 77014 Plastic Clean Water - Automatic 65041 Plastic Dirty Water - Automatic PRODUCT DESCRIPTION PRODUCT DESCRIPTION 1. 2. 3. 4. 5. 6. 1. 2. 3. 4. 5. 6.
SAFTEY INSTRUCTIONS Please note: Before assembling and putting the pump into operation, in all cases read through the operating manual. For safety reasons, those persons who have not read through the operating manual may not use the pump. The pump is intended for use ONLY by adults who have fully read and understand these instructions. Whenever Water and Electric are in the same place there are risks of electrocution and serious injury or death.
Safety point for your RCCB Please test the instrument before you use it Notice: 1.Insert the plug into the socket 2.Press the “RESET” button. The working indication on light will become red. 3.Press the “T” button. The working indication light should go out. 4.Press the “RESET” button to start. Please do not use this instrument when there is a fault in the above-mentioned process test. Test before use it. PUTTING THE PUMP INTO OPERATION Attach the hose (Fig. C and D).
UTILISATION / RANGE OF APPLICATIONS Electric submersible pumps are used in the following areas: Draining of cisterns, rainwater reservoirs, wells, ponds, swimming pools and storm drains. Draining of flooded cellars, boats and yachts. For aeration and water circulation. Please Note: Special Instructions: Avoid the intake of larger stones! maximum percentage of 5% solid materials for dirty water pump. Basically, all other fluids are not permitted.
Overloading Protection / Thermal Motor Switch The submersible pump is equipped with a thermal motor switch. In the event that the motor becomes overheated, the motor switch automatically switches the pump off. The cooling period amounts to 25 minutes and subsequently, the pump switches on again automatically. In the event that the motor switch operates, it is absolutely essential to find and eliminate the cause (Also see; Troubleshooting Guide).
TROUBLESHOOTING GUIDE Problem: Possible Causes: Remedy: The pump switches itself off because of overheating. (thermal motor switch) The water level is too low. Submerge the pump more deeply. Clogged by drawn-in particles Foreign matter jammed in the pump rotor. Check and clean the pump. The temperature of the pumped fluid is too high. Reduce the temperature of the fluid. It may not exceed +35° C in continuous operation. Wait for approx. 26 minutes for the motor to cool (motor switch).
Declaration of Conformity We, Importer SFD Ltd BA22 8RT Declare that the product Automatic submersible Water Pumps Complies with the essential health and safety requirements of the following directives: 89/336/EEC – EMC Directive.
EDFN FRYHU
