User`s manual

Network Video Recorder User’s Manual
Recording & Playback
1 General Setting for Recording
1.1
Hard Disk Configuration
1.1.1
Before Installing HDD
Make sure that system is properly shut down before you install or detach HDD from the
server, since there is high possibility that File system may be affected by improper
handling of HDD.
Make sure that Jumper of HDD is on Master position before you install HDD. Otherwise,
HDD will not be recognized by the server. You need to refer to User’s Guide of HDD for
jumper Setting.
When you use already formatted HDD (Linux file system or FAT32), only the first
partition of HDD will be used for recording. However, it is highly recommended to format
HDD before you start recording.
1.1.2 File System Type
NSS-1016 support either Linux native file system(ext3) and Window FAT 32 and you can
select any type you would like to use. After power on, NSS detect the type of HDD file
system and use it.
File System Type Description
Linux file system
(default)
Minimize any possible file crash in case of sudden power
down or inappropriate system down. But user can not read
data directly when the recorded HDD cartridge is inserted into
desk- top PC with Window OS, since it is Linux file system.
Window file system
(FAT32)
Windows file system can be read from any Windows O/S,
when removal HDD Cartridge is collected from different place
and inserted into other Window PC. But high possibility file
system can be affected and crashed by sudden power shut
down. Thus, not recommended if there is power supply is not
stable.
1.1.3 Installation of HDD
NVR server hardware comes with HDD Rack only. Thus, user needs to procure supported
Seyeon Tech Co., Ltd
61