User`s manual

Network Video Recorder User’s Manual
8.2 AOIP configuration
As described above, once you register product in the AOIP server and Network setting is
correctly done to user AOIP function, you need to configure AOIP function in the
FlexWATCH
TM
server.
1) Check the “Enable” option to use AOIP function
2) Type in AOIP server address. Either Domain name or IP address can be typed in.
3) Select whether to use HTTP or NVCP-TX port. HTTP port must be selected to view
AOIP Server IP :
AOIP server IP is subject to change depending on where you are and who is your local
distributor, since AOIP server can be run by local distributor in some countries. If there is
no local AOIP service available, you can contact manufacturer to use. www.aoip.co.kr
is
AOIP Service address run by manufacturer.
HTTP Port:
This is enable HTTP connect to AOIP server. You must select “Enable” option.
NVCP-TX Port:
NVCP-Tx Port should be enabled only when video is transmitter to NDVR server such as
FW-5440 and FW-5000, or Video proxy server supplied by FlexWATCH
TM
server. If not, do
not enable this option.
9 Network Status
You can see all the network status configured in the system through “Network status”
option. Please Select “Network Status” menu in the Network configuration mode of
Admin Window.
Seyeon Tech Co., Ltd
59