User`s manual

Network Video Recorder User’s Manual
bash#
bash# netconfig eth1 10.10.222.30 255.255.0.0 10.10.1.1
Your network configuration was changed.
Shutting down interface ppp2 [ OK ]
Shutting down interface ppp1 [ OK ]
Shutting down interface eth1 [ OK ]
Shutting down interface eth0 [ OK ]
Disabling IPv4 packet forwarding [ OK ]
Setting network parameters [ OK ]
Bringing up interface lo [ OK ]
Bringing up interface eth0 [ OK ]
Bringing up interface eth1 [ OK ]
Bringing up interface ppp1 [ OK ]
Your new network configuration was applied.
bash#
‘Eth1’ is to set up IP at ‘WAN Port’.
If you type in eth0, it will set up IP at ‘LAN Port’.
9) To check whether your Network configuration is correctly applied or not, press
‘ifconfig’ command, then following messages will show up. On the second line of the
‘eth1’ message, you can check the assigned IP and Mask values. Gateway value is not
seen here. If the values are different from what you want to set-up, try again the
Network configuration from step 8).
Bash# ifconfig
eth0 Link encap:Ethernet HWaddr 00:30:6F:48:64:86
inet addr:10.20.30.40 Bcast:10.20.30.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:9
eth1 Link encap:Ethernet HWaddr 00:30:6F:48:E4:86
inet addr:10.10.222.30 Bcast:10.255.255.255 Mask:255.255.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1453 errors:0 dropped:0 overruns:0 frame:0
TX packets:62 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:10 Base address:0x2100
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:309 errors:0 dropped:0 overruns:0 frame:0
TX packets:309 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
Seyeon Tech Co., Ltd
28