User`s manual

Network Video Recorder User’s Manual

8) Click “Save IP Address” button to save IP-Address in the Flash Memory.

9) Click “Go to Home Page” button to access to FlexWATCH

Web browser.

10) For server configuration, click “Admin” Icon and Input User ID and Password

(Factory default is root : root) to get into configuration mode and then press “OK”

button.



Note

Once you changed the IP address of FlexWATCH

NVR server, you need to connect the

server with the changed IP address. If you lost the IP address assigned to FlexWATCH

NVR server, you need to set-up a new IP address again.

Note

If IP address set result is failed, please check whether correct IP/MAC address is entered.

And try again with correct IP/MAC address, or please use HyperTerminal method.

4.3 IP Assignment through Hyper Terminal mode

Microsoft Windows provides Terminal emulation program, namely Hyper Terminal. For

HyperTerminal connection, Power, RS-232 Cable and LAN cable must be connected to

FlexWATCH

server with user’s PC. LAN cable is to run Web browser after configuration

using HyperTerminal. You can continue below configuration after Network setting, and the

next process will be same as using Installation Wizard Program.

1) Link up with the provided serial cable between COM port at FW-5440 and COM1 or

COM2 at user’s PC.

2) Run Hyper Terminal Program on user’s PC.

Window start> Program> Accessory> Communication> Hyper Terminal

Seyeon Tech Co., Ltd