User`s manual

Network Video Recorder User’s Manual

2.1.2 DHCP Enabled PC

If your PC is set to use DHCP, you need to check out IP address of your PC using

‘ ipconfig’ command at DOS Prompt window.

You need to get IP address from your network administrator to assign it to FlexWATCH

server. IP address should be Surplus of IP address which will be not randomly assigned to

any network device in your network.

Your network administrator must make sure that IP address should be excluded from IP

pool when he configure Router.

Ethernet adapter Local Area Connection:

Connection-specific DNS Suffix . :

Description . . . . . . . . . . . : 3Com EtherLink III

ISA (3C509/3C509) in Legacy mode

Physical Address. . . . . . . . . : 00-60-08-3C-40-90

DHCP Enabled. . . . . . . . . . . : Yes

Autoconfiguration Enabled . . . . : Yes

IP Address. . . . . . . . . . . . : 192.168.0.158

Subnet Mask . . . . . . . . . . . : 255.255.255.0

Default Gateway . . . . . . . . . : 192.168.0.1

DHCP Server . . . . . . . . . . . : 192.168.0.1

DNS Servers . . . . . . . . . . . : 168.126.63.1

168.126.63.2

C:\>

2.2 LAN cable or Cross-Over Cable

Check out whether FlexWATCH

server can be connected through LAN cable or Cross--

over cable.

2.2.1 LAN Cable Environment

If your PC is connected to network through LAN cable, you need to connect FlexWATCH

server to LAN port of Hub or Router.

Seyeon Tech Co., Ltd